Elenco Computer Inteface for Snap Circuits&reg Manual do Utilizador Página 13

  • Descarregar
  • Adicionar aos meus manuais
  • Imprimir
  • Página
    / 60
  • Índice
  • MARCADORES
  • Avaliado. / 5. Com base em avaliações de clientes
Vista de página 12
-12-
Build the circuit shown. If continuing from the previous experiment
then close the Winscope program and run it again, to reset the
settings. Click on the On-Line button to activate, and turn on the
switch (snap part S1). Set Winscope to the settings shown below,
and move the lever on the adjustable resistor (snap part RV)
around to change the waveform and the sound. A sample
waveform is shown here, but the pattern and shape of the pulses
depends on the adjustable resistor setting.
WaveformOn-Line
button
Without Storage Mode
Winscope has a mode that can display multiple scans at the same
time, called Storage mode. Set the adjustable resistor lever to a
low-middle position, place Winscope in this mode, and watch the
results.
With Storage Mode
Storage
mode
Vista de página 12
1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 59 60

Comentários a estes Manuais

Sem comentários