Elenco Compact Digital Multimeter Manual do Utilizador descarregar pdf (Página 8)

r Put the ball bearings into two opposite indents in

the case top as shown in Figure M.

r Place the six slide contacts on the selector knobs

as shown.

r Place the selector knob into the case top so that

the springs fit over the ball bearings as shown.

r Place the PC board over the selector knob. Be

sure that the 8-pin socket slides into its hole. Then

fasten the PC board with five 6mm screws as

shown.

r Insert the 200mA, 250V fuse into the fuse clips.

r Peel the backing off of the front label and place it

on the case top.

r Connect a 9V battery to the battery snap.

-7-

Figure M

PC board

6mm Screws

Slide

contacts

Rib

Close-up view

Ball bearings

Battery compartment

Case top

Selector knob

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 19 20

Sem comentários

Elenco Compact Digital Multimeter Manual do Utilizador Página 8